User manual

POSCOPE4 AND MEGA1+ MANUAL
38
www.poscope.com
Hint: If you click with left mouse button in the data table you can toggle between time calculation
between two cursors and frequency calculation.
In the right-bottom corner you can see estimated frequency calculation. It's an estimation and its
accuracy depends on your sampling frequency setting and your signals applied at the inputs. If your
sampling frequency is too high and signal frequency is too low the estimated calculation might be
wrong.
You can switch between 8-bit and 12- bit mode. 8-bit mode results in higher pipe mode sampling
frequency but less accurate data compared to 12-bit mode.