User manual

POSCOPE4 AND MEGA1+ MANUAL
34
www.poscope.com
Since the analog generator outputs a voltage amplitude of no more than 2V, you can set the channel
A knob to 2V. You will get graphical representation shown below.
Some signals change very fast. To catch the desired event, you can use triggering. Trigger is a
standard oscilloscope function that allows you to catch the live signal at some particular point so you
can closely analyze it. Just choose the correct channel, select Mode (automatic loops or a single
trigger) and particular edge of the trigger (signal rising / falling / any).
When you’re done with capturing the signal, you can closely examine it. Click Analyze in the top-right
corner of the PoScope4 software. Waveform will freeze.