Manual

Please note that this device is only a tool and cannot provide a 100%

reliable result due to the variety of materials and their compound. You

use this device at your own risk, we assume no liability for damages

resulting from the use of the device and exclude liability to the extent

permitted by law. There may be false detections as well as lines/mate-

rials not being detected. If plans are available, please consult them.

If you use other tools, please ensure that you wear appropriate protec-

tive equipment when working, e.g. consult the instructions for the tool

used.

When drilling, we recommend that you find out in advance where the

shut-oﬀ devices are located and ensure that they are freely accessible

so that you can react quickly if the worst comes to the worst.

BASIC INFORMATION AND OPERATION:

Aer switching on the detector, it is in metal detection

mode by default. If the display shows a signal in a

metal-free environment, calibration is required.

CALIBRATION:

Hold the detector in a metal-free environment (e.g. in

the air). Now press and hold the metal detection mode

button until the signal display returns to zero and the

green light illuminates again. Now release the key. The

calibration is completed.

6. USAGE