3 JDS2915 Dual-Channel Signal Generator
JDS2915 TABLE OF CONTENTS 1. Introduction 2. Device Overview 3. Shortcut Overview 4. Parameter settings in the main interface 5. Measuring and counting functions 6. Modulation mode 7. System settings 8. Other Informations 9. Support Published: 30.07.
JDS2915 1. INTRODUCTION Dear customer, Thank you very much for choosing our product. In the following we have listed what you have to consider during commissioning. 2. DEVICE OVERVIEW Function keys Button TTL-Input Ext.-Input 2,4“ LCD CH1-Output CH2-Output Short cuts Published: 30.07.
JDS2915 Power supply 5V DC Published: 30.07.
JDS2915 3. 1 CH1 Parameter 2 CH2 Parameter 3 waveform display 4 Channel output status 5 menu bar 6 Phase difference between CH1 and CH2 SHORTCUT OVERVIEW Configuration of the waveform Configuration of the measuring mode Activating the modulation mode system settings Control the output of CH1 and CH2. Used in other menus for control and confirmation (On/Off). Moving the cursor position Press and hold to select channel 1 as the main display.
JDS2915 4. PARAMETER SETTINGS IN THE MAIN INTERFACE Press the button to enable or disable simultaneous output for both channels. Use the and keys to switch between the respective channels. Pressing again while in the channel activates or deactivates the output. Press and hold the corresponding channel key to place the channel in the main interface. Press the button to activate the waveform. While the waveform is active, the shape can be changed quickly using the main button.
JDS2915 5. MEASURING AND COUNTING FUNCTIONS Press and then the button in the measuring mode to switch between the measuring function and the counting function. The input signal frequency, period, positive pulse width, duty cycle and other parameters can be measured. The measuring frequency range is between 1 Hz and 100 MHz. The measuring signal amplitude range is between 2 MVpp and 20 Vpp. The input interface is Ext.IN. Coupling setting: Press the button to switch between AC and DC mode.
JDS2915 6. MODULATION MODE Press the button to start the modulation mode. Press the button to switch between the sweep function (channel CH1/CH2), the pulse function (channel CH1) and the burst function (channel CH1). Sweep function: Here you can set any start and end frequency of the signal generator. The possible time is between 0.1 and 999.9s. In sweep mode (channel CH1), press the buttons to set the start and end frequency, time, direction and mode.
JDS2915 7. SYSTEM SETTINGS Press the button to open the setup menu. Use the buttons to navigate. The following settings can be made: In/Out position, sound settings, brightness configuration, language settings, synchronization, setting the arbitrary wave display. After you have opened a corresponding setting, you can configure it with the main button. Now press the corresponding button to save the settings. Sound settings: The tones can be activated or deactivated with the and buttons.
JDS2915 8. OTHER INFORMATION Our information and take-back obligations according to the Electrical and Electronic Equipment Act (ElektroG) Symbol on electrical and electronic equipment: This crossed-out dustbin means that electrical and electronic equipment does not belong in the household waste. You must return the waste to a collection point. Before handing over waste batteries and accumulators that are not enclosed by waste equipment must be separated from it.
JDS2915 9. SUPPORT We are also there for you after the purchase. If you still have questions or problems, we are also available by e-mail, telephone and ticket support system. E-Mail: service@joy-it.net Ticket-System: http://support.joy-it.net Phone: +49 (0)2845 98469 – 66 (9:30 - 17:00 o‘clock) For further information please visit our website: www.joy-it.net Published: 30.07.
