Instructions

www.joy-it.net
Pascalstr. 8 47506 Neukirchen-Vluyn
2. COMMISSIONING WITH THE RASPBERRY PI
Raspberry Pi Mosfet
GND (Pin 6) GND (Pin1)
3v3 (Pin 1) VCC (Pin2)
NC NC (Pin3)
BCM23 (Pin 16) Signal (Pin4)
Wiring:
Code example:
If the signal pin is set to high, the output is activated.
In the following code example, the output is activated every 15 seconds for 10 seconds.
Vin
- +
- +
Vout
from time import sleep
import RPi.GPIO as GPIO
GPIO.setmode(GPIO.BOARD)
Signal_Pin = 16
GPIO.setup(Signal_Pin, GPIO.OUT)
try:
while True:
GPIO.output(Signal_Pin, GPIO.HIGH)
print ("Output enabled")
sleep (10)
GPIO.output(Signal_Pin, GPIO.LOW)
print ("Output disabled")
sleep (5)
except KeyboardInterrupt:
GPIO.cleanup()