User manual
Ausgabe 19.05.2017 Copyright by Joy-IT 35
5.12 Project 12: Flamesensor
The Flamesensor (infrared receiving triode) is specially used by robots
to nd amesources.
This sensor has a high sensivity to ames because infrared rays are
very sensive to re.
It has a specially build Infared-Receiverpipe to detect re and convert
the light of the ames to a signal.
These signals are processed by the central processor.
If the sensor is approaching a re, the analog voltage is changing.
If no re is close, the voltage is by roughly 0.3V.
If a re is close, the voltage is at 1V.
The higher the voltage, the closer the re.
Hardware Amount
Mega2560 board 1
USB cable 1
Flamesensor 1
Buzzer 1
10kΩ Resistor 1
Breadboard 1
Breadboard cable 6