User manual

Ausgabe 19.05.2017 Copyright by Joy-IT 11
5.2 Project 2: ashing LED
The ashing LED project is quite easy.
We already discovered the LED in the previous project.
This me we will connect the LED to a digital port.
Diesmal werden wir eine LED mit einem der digitalen Pins verbinden.
This is what we need:
Just connect the components as seen in the circuit diagram below.
We are going to use digital pin 10.
Connect the LED to a 220 Ohm resistor to avoid damage by higher currents.
Hardware Amount
Mega2560 board 1
USB cable 1
Red M5 LED 1
220Ω resistor 1
Breadboard 1
Breadboard cable 2