Instructions

If you start programming the Joy-IT ARD_Mega2560PRO, you have to install
a development environment and the drivers for the associated operating
system on your computer which is going to be used for programming.
The recommended development environment is the “Arduino IDE“ which
is released by the Arduino manufacturer as an open source soware. This
soware is aimed at beginners, due to concept and structure. It is
compatible to the Joy-IT ARD_Mega2560PRO and has next to the
development environment also the required drivers which make it
possible to start immediately.
The download for this soware can be found with the following link:
https://www.arduino.cc/en/Main/Soware
5. SOFTWARE SETUP
Aer installing the soware, the appropriate microcontroller board must be
set up in the programming environment. To do this follow the next two steps.
1. Select [Tools → Board] choose “Arduino / Genuino Mega or
Mega 2560“
4. SOFTWARE-INSTALLATION
2. Select [Tools → Port] choose the port marked with
„(Arduino / Genuino Mega or Mega 2560)