User's Manual

4
◆ Using the FM Digital Transmitter (first time usage):
Figure 8.
1. Connect the FM Transmitter to the Holder/Transmitter base. Press (Quick Key o ) of the
FM transmitter, the ”LCD Digital Display” will show out flash OK letters, around 3~5
seconds, as Figure 9.
Figure 9.
2. Then ”LCD Digital Display” shows out the pre-set radio frequency channel ﹝ 88.1MHz﹞ ,
as Figure 10. ﹝ For future usage, the ”LCD Digital Display” will show out the last used
radio frequency channel when the FM Digital Transmitter is powered on.﹞
Figure 10.
3. Install the Holder clip of iPod/ iPod mini into the Holder/Transmitter base 1. The LED
charging indicator will show out RED light when charging and GREEN light when charging
completed.
4. Turn on the radio, reduce the volume lower﹝ around 10%~20%﹞ , then adjust the radio frequency
channel to no-used channel. The radio will output as “zzz” sound.
※ Note: The RF channel output mark of the FM Digital Transmitter is 0.1MHz. When setup
the radio frequency channels, do not setup the channels as 88,01MHz, 89,25MHz … 99,55MHz etc.
Please do set up as 88,1MHz, 89,2MHz, 99,5MHz …etc.
5. Then adjust the radio frequency channel of the FM Digital Transmitter to the same radio frequency
channel of the radio. For the detailed radio frequency channel adjustment method please refer to
Adjustment Illustrations of Radio Frequency Channels..
l When the radio frequency channel of the FM Digital Transmitter is fixed to the same as the
radio frequency channel of the radio, the “zzz” sound of the radio will become mute.