User's Manual

2. Insert the power plug3 into the vehicle cigarette lighter adapter outlet (12V). The ”LCD
Digital Display” will show out letters PASS as power connects correct.
3. Install the new iPod into the Transmitter1. The ”LCD Digital Display” will show out flash
charging signal . When iPod battery is full, ”LCD Digital Display” will show out
battery signal .
※ Note: Power Plug3 and extension stick2 can be adjusted up and down to the required
angle and then screw in tightly.
※ Note: The cigarette lighter sleeve4 can be adapted on the power plug 3, when your
cigarette lighter is too big. Refer to Figure 2 or Figure 3.
※ Note: Attached Protection Pads can be used to compatible with iPod 2,0 10G, 15G, 30G,
40G. As Figure 4.
Figure 4.
4