ST-26 § Digital Transmitter§ User’s Manual 1
◆ Features: Input Voltage: DC+10V ~ +16V. Current : 2A﹝ Max.﹞ . Output RF range: 88.1MHz ~ 107.9MHz. Radio Frequency Adjustment: 0,1MHz / Per step. Radio Frequency Response: 50Hz ~ 15KHz. 3.5m/m Earphone socket for audio output or the cassette adapter. LCD ”Digital Display”. iPod Charging Function, charging Indicator included. Build in Memory Mode, user can setup or recall 10 radio frequency channels. Compatible with iPod 2,0 10G, 15G, 30G, 40G by attached Pads.
◆ Power Plug Installation Instruction & Notes: 1. Insert power plug3 into Transmitter1 and twist gently clockwise to “on” (on the back of Transmitter.) As Figure 2. Figure 2. If the car’s cigarette lighter or the set of Transmitter is too low or too close to the gear shifter, use extension stick2. Insert the extension stick2 into Transmitter1 by twisting gently clockwise to “on” (on the back of Transmitter.) Connect the power plug3 with the extension stick2. As Figure 3. Figure 3.
2. Insert the power plug3 into the vehicle cigarette lighter adapter outlet (12V). The ”LCD Digital Display” will show out letters PASS as power connects correct. 3. Install the new iPod into the Transmitter1. The ”LCD Digital Display” will show out flash charging signal . battery signal . When iPod battery is full, ”LCD Digital Display” will show out ※ Note: Power Plug3 and extension stick2 can be adjusted up and down to the required angle and then screw in tightly.
※ Note: The Earphone socket (φ 3.5) on the left side of the Transmitter, can be connected with cassette adapter (optional product, not included in the package). As Figure 5. Figure 5. ◆ Desktop Kit Installation Instruction (optional): If you have purchased the Desktop Kit for iPod Digital Transmitter (sales separated as optional accessories, not included in the package), See Figure 6. Figure 6.
6. Then display the iPod music through the radio. 7. Adjust the volume through your radio until the satisfactory output is reached. 8. Set up the radio frequency channels once. The Digital Transmitter can memorized or recall the radio frequency channels being saved. 9. The Digital Transmitter can memorize 10 radio frequency channels. For the detailed radio frequency channel setting methods, please refer to Operating Illustration.
FCC ID. QPRST26 FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
