User's Manual

8| DLO TRANSPOD FOR IPOD SHUFFLE USER GUIDE
| 9
4. Repeat steps 1 and 2 for preset channels 3 and 4 (if available) to set all 4
TransPod for iPod shuffle presets.
Getting the best sound quality with your DLO TransPod for iPod shuffle
Make sure the frequency you’ve tuned to is empty and not near a strong
station. A good place to start is channel 88.5, which is the default frequen-
cy on the TransPod for iPod shuffle and is often open.
The TransPod for iPod shuffle will tune to any radio frequency, from 87.9
to 107.9, so try the entire spectrum until you find an unoccupied channel.
To learn more see
Finding Empty Radio Frequencies [pg 7].
Recorded music has many different styles and levels. The volume on the
shuffle may need to be adjusted for these different types of music to
achieve the best sound quality possible.
Once you’ve set the volume level on your shuffle for the best performance,
use the car stereo’s volume control to adjust the overall volume level of
your music.
The iPod shuffle’s volume setting is not memorized - it changes each time
you turn the shuffle on and off, so you may have to adjust the shuffle’s vol-
ume each time you use the TransPod for iPod shuffle in your car.
example 103.5 to 103.1. You can often find empty frequencies this way. If
that frequency is taken, try scanning to the next station and try again.
Save a preset station on your radio when you find a frequency that works
well in your area. Then set these presets on your TransPod for iPod shuffle
for different driving areas (ie. CH01 for home, CH02 for your commute,
etc). To learn how to set your presets on your TransPod for iPod shuffle
read
Setting Preset Stations on your TransPod for iPod shuffle [pg 8].
Tuning Your DLO TransPod for iPod shuffle
To tune your TransPod for iPod shuffle, use the tuning buttons on either side
of the unit – right for tuning up, left for tuning down.
The DLO TransPod for iPod shuffle has 4 preset stations. The default frequen-
cies for these presets are 87.9, 94.9, 100.9, and 107.9. To cycle through these
presets, press both tuning buttons at the same time.
Setting Preset Stations on your TransPod for iPod shuffle
To set your own preset stations follow these simple steps:
1. Tune the TransPod for iPod shuffle to the station you’d like to set.
2. Press and hold both tuning buttons simultaneously for 3 seconds. The dis-
play on the TransPod for iPod shuffle will flash the preset channel you just
set, e.g., CHO1.
3. To add a second preset, cycle to another preset number by pressing the
tuning buttons at the same time and repeat step 2.
NOTE: Your new preset
will override whatever preset was last saved on for that channel.