User Manual

8
6) Power saving mode*
After 10 minutes in the sleep mode, the iSolder-40 will turn to the power
saving mode, where no power is delivered to the tip at all and the tip
temperature drops down to room temperature.
The power saving mode is a safety mode where the device can get out of it
by moving the hand piece to left or right direction.
Also to shift from operating mode switch Off/On the iSolder-40
The indication of this state is a flashing red led (short on; short off).
*The difference between the sleep mode led color indicator and the auto shut-down mode led color
indicator is the speed of flashing.
For sleep mode the led red flash speed is Off/on in seconds is 1/1.
For standby mode the led flash speed is Off/on in seconds is 5/1.