Operation Manual

13
6.0 Service
Warning! Any unauthorised change to the product is not allowed.
Only use original spare parts.
All service must be done when the stove is cold!
6.1 Changing the burn plates/inner
bottom plate
Fig.28
A
C
D
B
E
F
• Remove the baffle plate (Fig. 28 A)
• Remove the side burn plates (Fig. 28 E) by lifting them up a
little and then out. (Be aware if using tools, that vermiculite
plates may be damaged by rough handling).
• Unscrew the M8x25 mm screw on the rear burn plate
(Fig. 28 F) and remove the burn plate.
• Then lift up and remove the inner bottom plate (Fig. 28 C).
Follow the same procedure for installation, but in the opposite
sequence.
6.2 Changing the baffle plate
• Lift the baffle plate (Fig. 28 A) and remove it through the door.
Access is then easy to baffle plate II (Fig. 28 B) if this needs to
be removed. This is situated on 1 knob on the side burn plate
and on the air manifold (Fig. 28 D).
• Edge it down and remove it through the door.
For re-installation follow the same procedure in the opposite
sequence.
6.3 Adjusting the base door
Fig. 29
A
B
C
6.4 Changing the glass in the side
panels
If needed the glass in the side panel can be replaced.
Fig. 30
1.
Remove the base door by pressing against the rear of
the hinge.
ENGLISH