User's Manual

www.jotron.com

85355_UM_AIS-SART_F

www.jotron.com

Number of red LED ﬂash Fault indication

2 Transmit power failure

3 Low battery

4 Transmit frequency error

5 User ID not programmed

6 Undeﬁned, contact Jotron

7 Internal communication error

5.3 TEST

1. Test must be conducted outdoors with a clear view to the sky to maximize

GPS location.

2. Move the switch to “TEST” position

until the LEDs start ﬂashing.

Tron AIS-SART will now run through a self

test procedure. If a Red LED ﬂashes, it

is indication of critical faults. *See table

below for error codes.

3. Release the switch when both LEDs start ﬂashing.

The unit will now search for GPS position for maxi-

mum 15 minutes.

4. A successful test is indicated by 15 second beep

and Green LED . See next page for description of in-

dication on a AIS transponder/ Electronic chart etc

5. An unsuccessful test is indicated by 15 second

beep and Red LED. Please relocate the unit and

restart test.

6. To cancel ongoing test, hold the switch on the

Tron AIS-SART in the “TEST” position until the buz-

zer starts to beep.

*Error codes if

RED ﬂash in“2.”