User's Manual

26
www.jotron.com www.jotron.com
87634_UM_TRON_40VDR_A
1. Release FB-40 top cover by removing the cotter pin.
2.Take Tron 40VDR out of the bracket.
3.Move Switch to TEST-position twice within 3 seconds and release back to
READY-position
4. EPIRB will BEEP shortly every 3 seconds until GPS position acquired
5. OK = 2 BEEPS (see chap 6.1.3 if Not OK)
6. Normal SELF-TEST is performed after successful GPS TEST and
position transmitted on 406.037 MHz. GPS position may also be received
on an EPIRB Tester for verification
6.1.3 EPIRB ERROR MESSAGES
If the self test detects a fault in the EPIRB module, one or more of the following
indications are shown:
Number of flashes: Fault indication:
1 NONE
2 Low power on 406 MHz transmitter
3 Low battery voltage
4 Low power on 121.5 MHz transmitter
5 PLL on 406 MHz transmitter out of lock
6 PLL on 121.5 MHz transmitter out of lock
7 EPIRB module not programmed or programming not
complete
GPS-test error messages:
a) 5 BEEPS = Did not acquire GPS position
b) 10 -” - = Number of GPS TEST above limit (>60)