User's Manual

a module solution provider
Regulatory information/warning
End Product Labeling
When the module is installed in the host device, the FCC/IC ID label must be visible through
a window on the final device or it must be visible when an access panel, door or cover is
easily re-moved. If not, a second label must be placed on the outside of the final device that
contains the following text: “Contains FCC ID: WS2-WG7831DELF” “Contains IC: 10462A-
WG7831DELF “
The grantee's FCC ID/IC ID can be used only when all FCC/IC compliance requirements are
met.
This device is intended only for OEM integrators under the following conditions:
(1) The antenna must be installed such that 20 cm is maintained between the antenna and
users,
(2) The transmitter module may not be co-located with any other transmitter or antenna.
(3) The Chip antenna with -2.46 dBi gain was verified in the conformity testing. Radiated
transmit power must be equal to or lower than that specified in the FCC/IC Grant of
Equipment Authorization for FCC ID: WS2-WG7831DELF and IC: 10462A-WG7831DELF. A
separate approval is required for all other antenna type, or higher gain antenna.