User's Manual

Doc No: WG1300-00 EM Board-UG-D01

http://WWW.JORJIN.COM.TW

CONFIDENTIAL

Page 7

2.3. Hardware Setup

Before conducting performance test, EM Board should be connected

to Host platform, either with mating connectors, J6 and J7, or single

row headers, J4 and J5. For the case of using EM mating connector for

hardware connection, the mating EM connector should be lined up

and spaced 1.2” apart as Figure 3 below

Figure 3. Host PCB Mating Connector Arrangement

For the case of using single row headers, the necessary signals as the

ones brought out from EM mating connector need to be wired to Host

platform.