User's Manual

Doc No: WG1300-00 EM Board-UG-D01

http://WWW.JORJIN.COM.TW

CONFIDENTIAL

Page 3

Items Key Parts Descriptions

CC3000-WG1300-00

Module

The core module for performance evaluation. It’s

related feature can be referred to its datasheet.

2 Antenna It can used for radiated test by reworking cpacitor

to correct pads.

3 J1 It’s a U.FL RF connector via which you can proceed

conducted power test.

It is a jumper via which we can swap testing modes,

test mode and operation mode. When pin 2 and

pin 3 are shorted, it runs in operation mode and it

operate in test mode when pin 1 and pin 2 are

shorted.

It is a jumper for testing power consumption. In

operation mode, pins of the jumper is shorted. For

power testing, the jumper is removed and ammeter

crosses the pins to do the testing.

6 J4 Refer to Table 2. For more details on these

through-hole test points

7 J5 Refer to Table 3. For more details on these

through-hole test points

Table 1. TOP-Side Key parts of WG1300-00 EM Board

Table 2 below shows the signal descriptions of J4

Number

Pin Name Pin Type Descriptions

1 GND Ground

2 NS_UARTD I/O Networking subsystem UART Debug line

3 FUNC4 -- Leave floating

4 WL_UART_DBG I/O UART Debug Line

5 WL_RS232_TX O Test RS232 transmit output; Leave floating

for normal operation

6 WL_RS232_RX I Test RS232 receive output; Leave floating