Quick Start Guide

Voice Control
When the headset is connected to the mobile phone, Triple taps on the MFB to activate voice
assistant.
Reset to Factory Settings
Open the cover of the charging case, keep the left & right earphones in the charging case,press
and hold the Reset Button for 10 seconds until the Charging Case Indicator Light flashes, the
earphones will enter factory settings state, and then complete the new device pairing on the
device Bluetooth interface.
Indicator/Voice Prompt Guide
Mode Description Voice prompts
Power On Earphones will turn on when the cover of the
charging case is opened.
Power Off
Place the earphones in the charging case and
close.
Pairing Earphones will start searching for last connected
device when power on, if no device found, it
goes to pairing mode
automatically. In pairing
mode, Indicator Light flashes red and white
alternately.
Connected
When the earphones are connected to your
device, “connected” will be heard.
“Connected”
Earphones charging
When the earphones are charging, white –
Indicator Light is on, and goes off when it is fully
charged.
-
Charging case
When the charging case is charging, white –
Charging Case Indicator Light is on, and goes on
when it is fully charged.
-
Cautions
* After removing the earphones from the charging case, without pressing any buttons, the left
and right earpieces will connect automatically. When no connections found, it will enter
automatic pairing mode.
* Please place the earphones in the correct location (L/R) for normal charging.
* Replacement of battery (on your own) is not recommended.
* Do not expose battery (battery pack) to excessive heat such as direct sunlight or fire.