J O N S E R E D cop_jonsered 2006.
SK PRÍRUČKA DÔLEŽITÉ UPOZORNENIE: Než začnete prístroj používať, pozorne si prečítajte túto príručku. Príručku si ponechajte, neskôr ju môžete znovu potrebovať LT NAUDOJIMOSI INSTRUKCIJA SVARBI INFORMACIJA: prieš pradedant dirbti įrenginiu, prašome atidžiaiperskaityti šią instrukciją ir įsitikinti, kad viską supratote. Išsaugokite ją tolimesniam naudojimui. SL KNJIŽICA Z NAVODILI POMEMBNA NAVODILA: Pozorno preberite navodila. Dobro jih morate razumeti, preden začnete uporabljati to orodje.
Questo manuale è stato redatto per essere utilizzato con diversi modelli di rasaerba con forme ed equipaggiamenti differenti. This manual has been prepared for use with different models of lawn mowers having different shapes and equipment.. Ez a kézikönyv, azért lett létrehozva, hogy segítségre legyen a különböző formájú és felszerelésű elektromos fűnyíró gépeknél. Diese Bedienungsanleitung wurde für verschiedene Rasenmäher geschrieben.
We wish to thank you for choosing our lawn mower. We are confident that the high quality of our machine will meet with your satisfaction and appreciation and that your lawn mower will give you long-lasting service.Before starting to use your machine, make sure to read with care this manual, which has been purposely drawn up to provide you with all the necessary information for proper use, in compliance with basic safety requirements. 1 Caution! Read the instruction manual before use.
SAFETY RULES Training a)Anyone who is not aware of the instructions for use shall not use the lawn mower. Do not allow children or anyone who has not understood these instructions to use the lawn mower. A minimum age for using the machine can be fixed by local regulations. b)The operator is responsible for the safety of other people in the working area. Keep children and domestic animals at a safe distance when the lawn mower is in use. c)This machine is to be used exclusively for cutting natural grass.
DESCRIPTION 1 2 3 4 5 6 7 8 9 10 11 Upper handles Fuel-enrichment pump Fastening knobs for upper handles Grass catcher Oil filler cap Oil drain plug Deck Adjusting levers for cutting height Spark plug Fuel cap Engine start-grip 12 13 14 15 16 17 18 Rear deflector Throttle lever Engine stop lever Reduction gear Touch-N-Mow handle Touch-N-Mow key Clutch lever ASSEMBLY OF GRASS CATCHER ASSEMBLY DEFLECTOR (if not already assembly) Assembly deflector ,only for the models with this equipment (Fig.
OPERATION ENGINE ADJUSTMENTS (Fig.JI) Refer to the engine manufacturer’s maintenance manual. CAUTION:- 0.6l Oil must be added to the engine before use STARTING THE ENGINE (Fig.
Start up with Touch-N-Mow Unloading the Touch-N-Mow system Make sure that no person or object is near the machine and all protection devices are installed and operating. Remain behind the handgrip in the position required for use. - Insert the key (17) and rotate it to RUN position. - Act on the safety lever (14) ) and keep it pressed against the handgrip. - Push the Touch-N-Mow start lever (16) forward and check the motor start up.
BLADE To remove the blade (27) unscrew the screw (28). Check the conditions of the blade-support (29), the washer (30), the key (31) and the washer (32) and replace any parts which are damaged. When reassembling, make sure that the key (31) is correctly seated in the shaft and that the cutting edges face in the direction of the engine rotation. The blade screw (28) must be torqued to 5,34 Kgm (52,4 Nm).
13 13 13 1 18 14 14 18 14 1 1 16 11 12 17 5 9 4 3 8 15 10 6 2 7 13 1 18 14 14 18 11 12 13 5 1 9 4 11 4 3 3 12 5 8 2 9 15 10 7 6 2 8 15 10 6 7
2 13 18 13 14 14 13 11 20
18 18 13 13 14 14 16 16 11 13 18 14 P S R 24 23 25 22
26 31 29 27 30 32 28
A LM2147 B C 46 cm D 96 dB (A) E 95 dB (A) F 84 dB (A) G 14 m/s2 A LM2150 B C 53 cm D 100 dB (A) E 99 dB (A) F 84 dB (A) G 12 m/s2 A LM2154 B C 50,2 cm D 100 dB (A) E 99 dB (A) F 88 dB (A) G 12 m/s2
HUSQVARNA OUTDOOR PRODUCTS ITALIA S.P.A. Headquarters: Via Como 72 - 32868 - VALMADRERA (LC) - ITALY- Tel. +39 0341 203111 - Fax +39 0341 581671 COD. 99991747 - 531213800 ED.01/2006 Q.
