Use and Care Manual

Fitting the trimmer guard and

trimmer head (Model GTS 2228)

S Fit the correct trimmer guard (A) for use!"#$%!$%&

$'#((&'!%&)*+!,--.!$%&!$'#((&'!/0)'*12-(3#4)5

$#-4!/0)'*!-4$-!$%&!6#$$#4/!-4!$%&!7%)6$!)4*!7&20'&

"#$%!$%&!3-8$!9:;+

NOTE: Make sure unit is assembled cor'&2$8<!)7

7%-"4!#4!$%#7!()40)8.

Fitting the loop handle

S Position the handle on the shaft. Note!$%)$!$%&

handle!(07$!3&!(-04$&*!3&$"&&4!$%&!$"-!)''-"7

on!$%&!7%)6$+

S Fit the screw, securing plate and wing!40$!)7

7%-"4!#4!$%&!*#)/')(+

S Tighten!"#$!%&'(!')"*

S Fit the drive disc (B) on the output shaft.

S Turn the shaft until one of the holes in the!+,&-$

dis.!/0&('1!%&"#!"#$!.2,,$132'+&'(!#20$!&'!"#$!

gear!#2)1&'(*

S Insert hex wrench (C) in the hole to lock!"#$

s#/4"*

S Screw on the trimmer head (H) in the op321&"$

dir$."&2'!"2!"#$!+&,$."&2'!24!,2"/"&2'*

!!!5!62!+&17/'"0$8!42002%!"#$!&'1",)."&2'1!&'!"#$!,$-9

!!!!!!$,1$!2,+$,*

ASSEMBLY

Fitting the trimmer guard and

trimmHU KHDG 0R G HO*7

S Fit the correct trimmer guard (A) for use with the

trimmer head. Hook the trimmer guard/combina-

tion guard onto the fitting on the shaft and secure

with the wing nut (B).

S Fit the dust cup (C) on the shaft. The nut must be

completely covered by the dust cup.

S Hold the dust cup with a wrench to pre

vent the

from rotating.

S S

w the trimmer head (D) onto the shaft.

S To dismantle, follow the instructions in the rev-

erse order.