Installation Guide

Waste and Overflow Trip Lever Drain Trim with Strainer

Installation Instructions

1. Remove worn Trip Lever Overflow Plate screws.

2. Carefully remove worn Trip Lever Overflow Plate, disconnecting the linkage

assembly from the back of the worn Trip Lever Overflow Plate.

3. Connect linkage assembly to the back of the new Trip Lever Overflow Plate.

4. Install new Trip Lever Overflow Plate. Align screw holes on the new Trip

Lever Overflow Plate and thread screws into place. Tighten with

screwdriver.

5. Remove worn Strainer by unthreading the screw.

6. Place new Strainer into the drain opening and thread screw through the

center hole, ensuring screw engages with the drain body. Tighten with

screwdriver.

Tools Needed for Installation:

• Screwdriver

PAGE 1
Waste and Overflow Trip Lever Drain Trim with Strainer Installation Instructions 1. Remove worn Trip Lever Overflow Plate screws. 2. Carefully remove worn Trip Lever Overflow Plate, disconnecting the linkage assembly from the back of the worn Trip Lever Overflow Plate. 3. Connect linkage assembly to the back of the new Trip Lever Overflow Plate. 4. Install new Trip Lever Overflow Plate. Align screw holes on the new Trip Lever Overflow Plate and thread screws into place. Tighten with screwdriver. 5.