Installation Guide

1. Fix the outlet box with machine screws.

2. Make wire connections, with wire connectors(A), following the reference chart listed below.

*Note: When parallel wire ( SPT I & SPT II ) is used. The neutral wire is square shaped

and ridged and the hot wire will be round in shape and smooth. ( See Illustration on left. )

Grounding Instructions:

a) For installation in the United States: Wrap ground wire from outlet box around green

ground screw on mounting bracket, no less than 2" from wire end. Tighten ground screw. If

fixture is supplied with a ground wire, connect to outlet ground wire with a wire connector.

b) For installation in Canada: If fixture is supplied with ground wire, wrap ground wire

around green grounding screw on mounting bracket. Tighten ground screw.

3. Orient the back plate(B) so that the machine screw protruding go into the holes in the back

plate, then secure it with the screwed ball(C)

4. Put the lamp body(D) onto the back plate and tighten with nuts(E)

5. Install bulbs(F). Be sure to use light bulb(F) with wattage no greater than specified on this

fixture. Always make sure that electrical current is turned off before changing bulbs.

ENJOY YOUR LAMP

Clear, Brown, Gold or Black without Tracer (colored stripes) Clear, Brown, Gold or Black with Tracer (colored stripes)

Insulated Wire (not green) with copper metal conductor Insulated Wire (not green) with Silver metal conductor.

PLEASE USE ON/OFF TYPE"B"BULB MAX 25-WATT OR CFL BULB MAX 9-WATT OR LED BULB MAX 5-WATT

THERE ARE 3PCS LED 4-WATT BULB IN THE BOX.

Black White

* Parallel Cord (round & smooth) * Parallel Cord (square & ridged)

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and

hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.

Estimated Assembly Time: 20 minutes.

Connect, Hot, Black or Red Outlet Supply Wire to: Connect, Neutral, White Outlet Supply Wire to: