Instructions / Assembly

1.Insert the Tube(H) into the swivel joint of the Lampbody(D) and rotate it clockwise till tight.

2.Raise the metal plate of the Beading cover(I) up, make sure the bottom end of the Tube(H)

extend through the center hole of the metal plate. Secure the Beading cover in place by turning

the final(G) onto the bottom end of the Tube(H) clockwise.

3. Insert the bulbs (J) into the Sockes. Be sure to use light bulb(J) with wattage no greater than

specified on this fixture. Make sure that electrical current is turned off before changing bulbs.

5.Attach each beading strand of the Beading cover(I) onto the top frame of the Lampbody(D).

6.Separate the Mounting Plate(A) from the Lampbody(D) by removing the Canopy Nut(E) anti-clockwise.

7.Attach the Mounting Plate (A) onto the J-box and secure it by turning 2 Mounting Screws (C)

clockwise till tight

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and

hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.

Estimated Assembly Time: 30 minutes.

PLEASUE USE TYPE"B" BULB MAX 40-WATT OR CFL BULB MAX 13-WATT OR LED MAX 9-WATT

THERE ARE 3 X 4W LED BULBS IN THE BOX.

2/2

clockwise

till

tight

*Note: When parallel wire ( SPT I & SPT II ) is used. The neutral wire is square shaped

and ridged and the hot wire will be round in shape and smooth. ( See Illustration on left. )

Grounding Instructions:

a) For installation in the United States: Wrap ground wire from outlet box around green

ground screw(F) on mounting bracket, no less than 2" from wire end. Tighten ground screw. If

fixture is supplied with a ground wire, connect to outlet ground wire with a wire connector.

b) For installation in Canada: If fixture is supplied with ground wire, wrap ground wire

around green grounding screw on mounting bracket. Tighten ground screw.

8.Attach the Canopy of the Lampbody(D) to the Mounting Plate (A) and fix it by turning the Canopy

Nut (E) clockwise.

* Parallel Cord (round & smooth) * Parallel Cord (square & ridged)

Clear, Brown, Gold or Black without Tracer (colored

stripes) Clear, Brown, Gold or Black with Tracer (colored stripes)

Insulated Wire (not green) with copper metal conductor Insulated Wire (not green) with Silver metal conductor.

Connect, Hot, Black or Red Outlet Supply Wire to: Connect, Neutral, White Outlet Supply Wire to:

Black White

ENJOY YOUR LAMP

2/2