Instructions / Assembly

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and
hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 20 minutes.
1. Thread mounting screws (A) into the mattch holes of the mounting plate(B),
then fix the mounting plate(B) to the outlet box with machine screw(C).
2. Place the tube(H) over the coupling of the body(I),then thread the canopy(F) into the coupling of the body(I).
3. Make wire connections, with wire connectors(E), following the reference chart listed below.
Connect, Hot, Black or Red Outlet Supply Wire to:
Connect, Neutral, White Outlet Supply Wire to:
Black
White
* Parallel Cord (round & smooth)
* Parallel Cord (square & ridged)
Clear, Brown, Gold or Black without Tracer (colored
stripes)
Clear, Brown, Gold or Black with Tracer (colored stripes)
Insulated Wire (not green) with copper metal conductor
Insulated Wire (not green) with Silver metal conductor.
*Note: When parallel wire ( SPT I & SPT II ) is used. The neutral wire is square shaped
and ridged and the hot wire will be round in shape and smooth. ( See Illustration on left. )
Grounding Instructions:
a) For installation in the United States: Wrap ground wire from outlet box around green
ground screw(D) on mounting plate, no less than 2" from wire end. Tighten ground screw. If
fixture is supplied with a ground wire, connect to outlet ground wire with a wire connector.
b) For installation in Canada: If fixture is supplied with ground wire, wrap ground wire
around green grounding screw on mounting plate. Tighten ground screw.
4. Orient the ceiling canopy(F) so that the mounting screws(A) protruding from the mounting plate(B) go into
the holes in the canopy(F),then secure it with the provided screwed balls(G).
4. Install bulb(M). Be sure to use light bulb(s) with wattage no greater than specified on this
fixture. Always make sure that electrical current is turned off before changing bulbs.
5. Have the opening of glass shade (N) go over the socket, insert one side of glass shade (N) opening over
the socket bracket (L), then adjust the glass shade(N) position and put the other side of the glass shade (N)
over the other side of the socket bracket (L), then position against the cap (K).
6. Carefully adjust the glass shade (N) placement and have it sit centered on top of the cap (K). Then thread down
the nut (J) and tighten together both socket bracket (L) and glass shade (N).
PLEASE USE ON/OFF TYPE"A" BULB MAX 60-WATT OR LED BULB MAX9 -WATT
THERE ARE LED 3PCS 4WATT BULB IN THE BOX
ENJOY YOUR LAMP
2/2