Instructions / Assembly
4.Make installation
Step C1: Mounting plate(D) to outlet box with mounting screws(E). The side of single bar marked "GND"
must face out
Step C2: Raise the canopy(G) through screw collar loop(H) and screw the collar loop(J) to a proper
position by measuring.Unscrew threaded ring(J)from screw collar loop(J)and remove the canopy(G).
In this way, you would know the proper position on which collar loop it should be located.
Step C3: Slip threaded ring(J) over the chain(K), then do the same with the canopy(G)
Step C4: Open the quick link(I) then attach to the collar loop(H). Close the quick link(I)
Pass the wires through collar loop(H) to the mounting plate, gently pull the tillsung
StepC5: Make wire connections
Connect wires as below wires connecting shown. TAKE NOTE OF YOUR COLOR OF FIXTURE,NEVER
CONNECT WIRES TO GROUND WIRES
Connect ground wire according to below chart Connect ground wire according to below chart
Twist plastic wire connector(A) until wires are tightly joined together, wrap each connector
with approved electrical tape for more secure connection and carefully stuff all wires into
the outlet box
StepC6: Install bulb(N) (Please do not exceed the maximum capacity recommended on the socket.)
5. Check everything is already installed properly, then you could turn on the light.
CLEANING
To clean,wipe fixture with a soft cloth,Do not use abrasive materials such as scouring pads or powders,
steel wool or abrasive paper.
ORDERINGPARTS
Keep this sheet for future reference, and in case you need to order replacement parts.
All parts for this fixture can be ordered from place of purchase. Be sure to use exact wording
from illustration when ordering parts.
第 4 页