Instructions / Assembly
TOOLS REQUIRED (NOT INCLUDED):
Before doing assembly and installation please prepare the needed tools as below picture
PARTS TYPE & QTY INCLUDING:
(A) Plastic wire connector (3)
(B) Hex nut (2)
(C) Green ground screw (1)
(D) Mounting plate (1)
(E) Mounting screw (2)
(F) Threaded nipple (1)
(G)Canopy (1)
(H) Screw collar loop (1)
(I) Quick link (2)
(J) Threaded ring (1)
(K) Chain (1)
(L) Loop (1)
(M) Antler chandelier main body (1)
(N) Bulb (6)
ASSEMBLY & INSTALLATION INSTRUCTIONS:
1. Carefully remove the fixture from the carton and check that all parts and
accessories are included as shown in the above illustration
2. Make assembly
If the group of parts are not already assembled:
Step A1:Fix the threaded nipple(F) into the screw collar loop(H)
Step A2:Thread the mounting plate(D) over the another end of threaded nipple(F),
Step A3:Place and tighten the hex nut(B) to secure the mounting plate(D) in place.At this point,
the side of mounting plate marked "GND" must face to the screw collar loop(H).
第 2 页