Instructions / Assembly

Option 2: Assembly instruction(Hard wired)
Part List and Hardware List
PIECE DESCRIPTION PICTURE QUANTITY PIECE DESCRIPTION PICTURE QUANTITY
A Wire Connrctor 3X H Wrench 1X
B Mounting Bracket 1X I Socket 1X
C Mounting Screws 2X J Shade 1X
D Ground Screw 1X K Socket Ring 1X
E Canopy 1X L Bulb 1X
F Screwed Balls 2X M Bracket 1X
G Screw Nut 1X
Installation
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and
hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 30 minutes.
1. Carefully cut pre -attached plug ,cord and switch to your desired length as shown and discard the part plug and switch .
2. Insert end of cord into corresponding hole of canopy ( E ),and mounting plate ( B ) as shown. Thread cord into bracket ( M ) as
shown.
Note: Cuting the cord so that they are at
least 6 inches (152.4mm) long within an
outlet box and extend max. 3.1m long
measured from the point where the cord
emerges from the body of the lamp.
3. Fix the mounting bracket(B) to the outlet box with machine screw(C).
4. Make wire connections, with wire connectors(A), following the reference chart listed below.
Connect, Hot, Black or Red Outlet Supply Wire to:
Connect, Neutral, White Outlet Supply Wire to:
Black (Hot)
White (Neutral)
* Parallel Cord (round & smooth) * Parallel Cord (square & ridged)
Clear, Brown, Gold or Black without Tracer
(colored stripes)
Clear, Brown, Gold or Black with Tracer (colored stripes)
Insulated Wire (not green) with copper metal conductor Insulated Wire (not green) with Silver metal conductor.
*Note: When parallel wire ( SPT I & SPT II ) is used. The neutral wire is square shaped
and ridged and the hot wire will be round in shape and smooth. ( See Illustration on left. )
3/4