Installation Guide

2. Fix the mounting bracket(A) to the outlet box with mounting screw(B).
3. Loose the studs(O) to remove from the Frame(K) .
4. Loose the Cap Nuts(M) and washer(N) to remove from the Frame(K) .
5. Fix the glass(J) to the tube(L) by using Cap Nuts(M) and washer(N)
6. Insert the bulb (I) into the socket (H).
7. Fix the Frame(K)) to the top hood (P)by Using 2pcs studs(O) .
8. Make wire connections, with wire connectors(F), following the reference chart listed below.
*Note: When parallel wire ( SPT I & SPT II ) is used. The neutral wire is square shaped
and ridged and the hot wire will be round in shape and smooth. ( See Illustration on left. )
Grounding Instructions:
a) For installation in the United States: Wrap ground wire from outlet box around green
ground screw(G) on mounting bracket, no less than 2" from wire end. Tighten ground screw. If
fixture is supplied with a ground wire, connect to outlet ground wire with a wire connector.
b) For installation in Canada: If fixture is supplied with ground wire, wrap ground wire
around green grounding screw on mounting bracket. Tighten ground screw.
9. Fix the base(C) to the Mounting bracket(A) by Using 2pcs screws(E) and washer(D) .
PLEASE USE TYPE"A" BULB MAX 25-WATT OR CFL BULB MAX
9-WATT OR LED BULB MAX 5-WATT
THERE IS 1PC 4 WATT LED BULB IN THE BOX
ENJOY YOUR LAMP
* Parallel Cord (round & smooth) * Parallel Cord (square & ridged)
Clear, Brown, Gold or Black without Tracer (colored stripes) Clear, Brown, Gold or Black with Tracer (colored stripes)
Insulated Wire (not green) with copper metal conductor Insulated Wire (not green) with Silver metal conductor.
Connect, Hot, Black or Red Outlet Supply Wire to: Connect, Neutral, White Outlet Supply Wire to:
Black White
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and
hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 20 minutes.
1. Loose The Screws(E) to Remove the Mounting bracket(A) from the base(C).