Installation Guide

2. Make pre‐installation
Step B1: Unscrew the tirm(N), hex nust(B) from the antler(P).
Carefully push the antler to make the threaded nipple through the hole on trim,
then secure with hex nuts(B),The sleeve (R) screw into the antler chandelier main body(M),
then the Round iron plate(Q) and the teeth are screwed through Tirm(N) into the other
end of the sleeve(R),then secure with hex nuts(B).
Step B2: Open the quick links (I) to connect the loops(L),Close the quick links(I)
Step C1: By measuring,determine the correct length of links needed. Use the chain pliers, 
open and discard the remaining chain.
Step C2: Attach a quick link(I) to the loop(L) above the trim(N) and to connect the end of chain(K).
Step C3: Gently lace wires through chain(K) to the top of the another quick link(I) and pull tillsung
3.Turn off power
第 3 页