Installation & Assembly

TEMPLATE INSTRUCTIONS FOR YOUR
730R
TO HANG CERAMIC PARTS:
Hardware Included:
Wall Anchor (X3)
Screw (X3)
Ceramic Body
Ceramic Finial
1. Mount backplate and shade as described in ASSEMBLY INSTRUCTIONS.
2. Lay template on level surface.
3. Place ceramic body over outline on template. Make sure edges are aligned as close as possible.
4. Flip ceramic body and template over, being careful to keep items aligned.
5. Mark key hole locations on back of template with a felt tip pen.
6. Set ceramic body aside. Carefully push the tip of the ink pen through key hole marks on the back of the template.
7. Place template below backplate and shade to determine desired placement of ceramic body. Once desired position is established,
mark key hole placement from template onto wall.
8. Carefully drill holes at marked locations. Insert wall anchors into holes. Thread screws into openings in wall anchors. Note: Do not
thread screws all the way into wall anchors. Leave aproximately 1/4” between the screw head and the wall.
9. Carefully slide the key holes on the back of the ceramic body over the exposed screw heads.
10. Rotate template 180 degrees and repeat steps 2 - 7 for nial placement.
11. Place template above backplate and shade to determine desired placement of ceramic nial. Once desired position is established,
mark key hole placement from template onto wall.
12. Carefully drill hole at marked location. Insert wall anchor into hole. Thread screw into opening in wall anchor. Note: Do not
thread screw all the way into wall anchor. Leave aproximately 1/4” between the screw head and the wall.
13. Carefully slide the key hole on the back of the ceramic nial over the exposed screw head.
RIGHT FACING GIRAFFE
CERAMIC SCONCE