Use and Care Manual

7
GREASE BEVEL, SPUR AND F A CE GEARS
Apply grease3.
to the bevel,
spur and face gear.
Reassembly:
Prior to closing the unit the bit index must be checked.1.
Load a bit into the barrel assembly.2.
The wire slot on the bit should be in the 12 O’clock position. If the3.
wire slot is not in the 12 O’clock position then proceed to step 4. If
the wire slot is in the 12 O’clock position then proceed to step 5.
Lift the barrel assembly from the gun assembly and rotate the4.
bit until the wire slot is in the 12 O’clock position. Reinstall the
barrel assembly into the gun housing. Insure the barrel-locating
pin is seated into its locating hole in the housing and that the bit
is still in the 12 O’clock position.
Reinstall top housing and Install the bottom 6-32x5/8 screw.5.
Install collet and nose piece, insuring that the collet-locating pin
is seated in the locating hole in the housing. Install
remaining screws.
WIRE SLOT