Use and Care Manual

BIT AND SLEEVE INSTALLATION:

Remove the tool from the box.1.

Install a Bit and Sleeve. Follow installation instructions below.2.

(Bits and Sleeves are sold separately. See page 5 for bit and

sleeve selection).

Loosen nose piece (nut).•

Insert the bit into the nose•

piece

Rotate until the bit is•

seated on the driver.

Place sleeve over the bit•

and slide the sleeve into

the nose piece. Rotate the

sleeve as you are sliding

the sleeve into the nose

piece until the sleeve

has engaged with the

collet pin, the sleeve will

then slide further into the

nose piece. The sleeve is

now seated.