Full Product Manual

The CMP-1226 8 Point Crimp Tool is used for crimping wires (12-26 AWG) and contacts for electrical connectors. The CMP-1226
requires a turret head (sold separately to perform the crimping operation. More info for the Turret Heads (CMP-3) can be found at
www.jonard.com.
Before crimping, a positioning or turret head needs to be installed on the CMP-1226 crimping tool. In the installation instructions
below we will be using the Jonard Tools CMP-3 front release turret head.
INSTALLATION INSTRUCTIONS
1. Ensure the Turret is exposed by pressing the Release Leveler on the side of the Turret Head.
2. Insert the Turret Head into the crimper by aligning the pin on the bottom of the Turret Head with the pin hole on the
crimper.
3. Using a hex key, tighten the two captive screws on the top of the Turret Head to lock the head in place.
4. Use the chart below (also on the Turret Head) to determine which position of the selector knob is needed based on the size
of the wire being used:
CONTACT SIZE POSITIONING AND MATING
END COLOR
26 24 22 20 18 16 14 12 WIRE SIZE
20-20 RED 1 2 3 4
SELECTOR NO.
16-22
BLUE
1 2 3
16-20* 1 2 3 4
16-16 4
12-16
YELLOW
4 5 6
12-12 5 6 7 8
*M39029/1-101 USE RED MATING END COLOR
Pin Hole
Pin needs to be
inserted into hole
Captive
Screws
Release Lever
Turret
CMP-3 Turret Head (sold separately)
CMP-1226 Crimp Tool
Alignment Hole Selector
FEATURES