Instruction Manual

WWW.JOHNSONSYSTEMS.COM 27
31. SERIAL# View the microcontroller’s unique eight-character silicone serial number.
XXXXXXXX Shows the unique eight-character serial number.
32. VERSION View the microcontroller’s software version.
VER X.X Shows the microcontroller’s software version.
33. DEFAULTS Set various system conguration settings to the factory default.
Press EXECUTE to enter the menu.
Press MENU ( ) to scroll through and select which item(s) to default.
3ØPATCH? Sets the dimmer phase patch to ABCABC. This is the default setting.
1ØPATCH? Sets the dimmer phase patch to ABABAB.
DMX PAT? Clears the DMX patch and sets as invalid.
DCPATCH? Clears the dimmer to channel patch and congures it for 1:1 operation.
CURVES? Sets all 6 dimmer curve proles to Square Law curve.
V-LIMIT? Sets the output voltage limit to full (127.5 or 255) on all 6 dimmer outputs.
FD-TIME? Sets the fade time at 5 seconds for all 6 scenes.
LOADSHD? Clears load shed patch for both auxiliary inputs.
SURE??? Press EXECUTE to select the item to default. Are you sure?
DONE!!! Press EXECUTE to set the selected default.
Press ESCAPE or RESET to exit the menu.
34. LED INT Set the LED intensity for the programming switches.
Press EXECUTE to enter the menu.
LEV:100% Press MENU ( ) to adjust the LED intensity from 0% to 100%.
LEV:050% Press MENU ( ) and MENU ( ) at the same time to toggle back to 50%.
Press ESCAPE to exit the menu and save the desired setting.
Press RESET to exit the menu without saving.
The menu will automatically timeout after 2 minutes of inactivity and save.
35. LCD VIEW Adjust the contrast of the LCD Display for optimum viewing.
Press EXECUTE to enter the menu.
ADJUST Press MENU ( ) to adjust the LCD contrast.
Press ESCAPE to exit the menu and save the desired LCD view.
Press RESET to exit the menu without saving.
The menu will automatically timeout after 2 minutes of inactivity and save.