Manualshelf

Instruction Manual

ManualsBrandsJohnson Systems ManualsLightingJ-PACK Series Dimmers
11121314151617181920
WWW.JOHNSONSYSTEMS.COM 17
Quick Programming Reference to System Configuration Menu Items
Basic Menus
1. ADDRESS Set the DMX start address.
2. DMX TERM Enable or disable the DMX termination.
Advanced Menus
3. SCENESET Enable and setup 6 different backup scenes.
4. FADETIME Set the fade time for each of the 6 scenes from 0 to 99 seconds.
5. SNAPSHOT Record DMX levels into the backup scenes.
6. DIM TEST Test the dimmer outputs one at a time, or all at once.
7. MONITOR View the control level to each dimmer output.
8. DMX O/P Congure the on-board DMX protocol manager for offset or patch mode.
9. DMX PAT Patch each of the 6 dimmer (PWM) outputs to any DMX input channel.
10. SH TIME Set the DMX status hold time from 0 to 99 minutes or innite.
11. DC PATCH Congure the dimmer to channel patch for the dimmer pack.
12. DIM CURV Congure the dimmer curve for each output.
13. VOUT LIM Set the maximum RMS output voltage for each dimmer.
14. REGULATE Enable or disable the dimmer output voltage regulation.
15. STANDBY Enable or disable the power savings standby mode.
16. TEST INC Set the test increment units to percent or hexadecimal.
17. SCENEMOD Enable or disable scene mode.
18. AUX TEST Test the auxiliary dry-contact inputs.
19. AUX1MODE Set the auxiliary input 1 mode to activate a selected scene or load shed.
20. AUX2MODE Set the auxiliary input 2 mode to activate a selected scene or load shed.
21. LOADSHED Select dimmers to be disabled (turned off) by the auxiliary inputs.
22. Ø-PATCH Set the zero-cross phase reference for each dimmer control output circuit.
23. WARMING Turn the “lamp warming” feature on or off.
24. V-RANGE Set the supply voltage range for 120 Volts or 240 Volts operation.
25. LINE V View the RMS line voltage for each power phase.
26. LINE F View the line frequency of phase A.
27. REM TEMP View the temperature of the remote temperature sensor.
28. CTL TEMP View the temperature of the microcontroller.
29. RTIME View the total run time of the microcontroller.
30. HARD-KEY View the microcontroller’s unique eight-character hard-key code.
31. SERIAL# View the microcontroller’s unique eight-character silicone serial number.
32. VERSION View the microcontroller’s rmware version.
33. DEFAULTS Set various system conguration settings to the factory default.
34. LED INT Set the LED intensity for the programming switches.
35. LCD VIEW Adjust the contrast of the LCD Display for optimum viewing.