Manual

www.johnsonsystems.com 21
31. BACKUP Backup parameters and save them in the EEPROM memory module.
All of the conguration setting parameters can be saved in the EEPROM memory
module for backup. The backup parameters can then be restored if they have been
inadvertently changed or corrupted. Once backup is complete the EEPROM memory
module may be removed for safe storage. All DPC-12 and DPC-24 control modules
are shipped with the factory default settings saved in the EEPROM memory module.
Press EXECUTE to enter the menu.
DISABLED This menu is disabled for inadvertent use. Proceed to enable.
ENABLED Press and hold MENU ( ) and MENU ( ) at the same time for 4-5 seconds.
MEMCHECK Automatically checks the EEPROM memory module for parameter type.
SURE ??? Press EXECUTE to proceed.
WAIT Automatically begins parameter backup and generates CRC value.
VERIFY Automatically veries parameter backup data and CRC value.
DONE!! Parameter backup is done and saved in the EEPROM memory module.
NO MEM! Displayed if an EEPROM memory module is not detected.
WRONG Displayed if the wrong type (parameter) of EEPROM memory module detected.
MEM TYPE Displayed if the wrong type (parameter) of EEPROM memory module detected.
WRONG Displayed if the wrong product type of EEPROM memory module detected.
PRODUCT Displayed if the wrong product type of EEPROM memory module detected.
DATA ERR Displayed when a data error occurs. Waits for key press to restart BACKUP.
NOTE: Be sure to BACKUP the DPC-12 or DPC-24 when installation conguration is
complete.
32. PRINTOUT Print various system conguration settings using a hand held infrared printer.
All DPC-12 and DPC-24 control modules come equipped with an infrared (I/R) LED
that provides the ability to printout all the system conguration settings, when used
in conjunction with a hand held infrared printer (Johnson System Inc., Part Number:
JS-IP). Point the hand held printer I/R LED directly at the DPC-12 or DPC-24 control
module I/R LED within 3 ft (1m).
Press EXECUTE to enter the menu.
Press MENU ( ) to scroll through and select which item(s) to printout.
SYSTEM? Prints general system information and conguration settings.
V-LIMIT? Prints the output voltage limit settings for each of the 12 or 24 dimmer outputs.
CURVES? Prints the dimmer curves for all 12 or 24 dimmer outputs.
Ø-PATCH? Prints the phase patch for all 12 or 24 dimmer outputs.
DCPATCH? Prints the conguration settings for the dimmer to channel patch.
SCENE>FL Press MENU ( ) to select the desired scene (01 to 12 or 24) or all scenes (FL).
SCENE? Prints the level settings for each dimmer output within the 12 or 24 scenes.
SCENE>01 Press EXECUTE to toggle the pointer (>) and select which scene to print.
FD-TIME? Prints the fade time settings for each of the 12 or 24 scenes.
2 ROOM? Prints the two room assignment for each of the 12 or 24 dimmer outputs.
ALL? Printout all items at once.
PRINTING Press EXECUTE on any item to begin printing.
Press ESCAPE or RESET to exit the menu.