Manual
Table Of Contents
- Warranty
- Introduction
- Packaging & Contents
- Installation
- DPC-24/12 Circuit Board
- DPC-12 and DPC-24 Control Module Face Panels
- Dual DMX Input and Thru Connectors
- User Interface
- LCD Display
- Programming Switches
- 12 or 24 Local Buttons/Switches
- System Status - LED Indicators
- System Status - LCD Display
- Quick Programming Reference to System Configuration Menu Items
- Detailed Programming of System Configuration Menu Items
- Troubleshooting Reference
- Important Hard-key Information
www.johnsonsystems.com 11
Quick Programming Reference to System Configuration Menu Items
Basic Menus
1. ADDRESS Set the DMX start address.
2. DMXA-TRM Enable or disable termination on the DMX-A input.
3. DMXB-TRM Enable or disable termination on the DMX-B input.
Advanced Menus
4. SCENESET Enable and setup 12 or 24 different backup scenes.
5. FADETIME Set the fade time for each of the 12 or 24 scenes from 0 to 99 seconds.
6. SNAPSHOT Record DMX levels into the backup scenes.
7. DIM TEST Test the dimmer outputs one at a time, or all at once.
8. MONITOR View the control level to each dimmer output.
9. DMX MODE Congure the mode of the on-board DMX protocol manager.
10. 2 RM SET Set the two room assignment for each of the dimmer outputs.
11. SH TIME Set the DMX status hold time from 0 to 99 minutes or innite.
12. DC PATCH Congure the dimmer to channel patch for the dimmer pack.
13. DIM CURV Congure the dimmer curve for each output.
14. VOUT LIM Set the maximum RMS output voltage for each dimmer.
15. REGULATE Enable or disable the dimmer output voltage regulation.
16. STANDBY Enable or disable the power savings standby mode.
17. TEST INC Set the test increment units to percent or hexadecimal.
18. L-BUTTON Set the mode of the 12 or 24 local buttons to scene, bump or disabled.
19. Ø-PATCH Set the zero-cross phase reference for each dimmer control output circuit.
20. V-RANGE Set the supply voltage range for 120 Volts or 240 Volts operation.
21. LINE V View the RMS line voltage for each power phase.
22. LINE F View the line frequency of phase A.
23. CTL TEMP View the temperature of the microcontroller.
24. RTIME View the total run time of the microcontroller.
25. HARD-KEY View the microcontroller’s unique six-character hard-key code.
26. SERIAL# View the microcontroller’s unique six-character silicone serial number.
27. VERSION View the microcontroller’s rmware version.
28. EEPROM View the type of EEPROM memory module plugged in.
29. FW-LOAD Load new rmware into the microcontroller via the EEPROM memory module.
30. RESTORE Restore parameters saved in the EEPROM memory module.
31. BACKUP Backup parameters and save them in the EEPROM memory module.
32. PRINTOUT Print various system conguration settings using a hand held infrared printer.
33. DEFAULTS Set various system conguration settings to the factory default.
34. LED INT Set the LED intensity for the programming switches.
35. LCD VIEW Adjust the contrast of the LCD Display for optimum viewing.