Product Manual

6. Operating Instructions

Alkaline Battery Installation

Note: Always check to be sure that the on/off switch is in the off

position before removing and replacing batteries.

1. As shown in figure, unscrew the battery cover and put 3 “AA”

alkaline batteries into the battery compartment noting the polarity

as shown in the battery compartment. Screw the battery cover

shut. Turn the on/off switch to on. If the power LED is flashing,

the battery is low.

IMPORTANT: It is the responsibility of the user to verify the

calibration of the laser before each use.

1623i-English_Manuals 12/21/16 12:12 PM Page 6