User's Manual

ASSEMBLY STEP 5
A Open RED HARDWARE BAG.
B Assemble the CONSOLE BASE to the
CONSOLE MASTS using BUTTON
SOCKET HEAD CAP SCREWS (15) and
FLAT WASHERS (14).
C Be sure to route the CONSOLE CABLES
down the CONSOLE MAST through the
larger opening in the mast which is closest to
the running belt.
D Make all appropriate wire connections within
the motor compartment.
15
BUTTON SOCKET HEAD CAP SCREW
Qty: 6
14
FLAT WASHER
Qty: 6
RED HARDWARE BAG CONTENTS :
ASSEMBLY STEP 6
A Open YELLOW HARDWARE BAG.
B Make appropriate wire connections to the
FACEPLATE and then assemble to the
CONSOLE BASE using SOCKET HEAD
CAP SCREWS (13), RIBBED LOCK
WASHERS (23), SOCKET HEAD CAP
SCREWS (16) and RIBBED LOCK
WASHERS (23).
C The SOCKET HEAD CAP SCREWS (16)
are shorter and must be assembled into the
holes closest to the running surface.
D All holes applicable to this assembly step
can be noted by the embossed arrow next to
the hole.
13
SOCKET HEAD CAP SCREW
Qty: 4
16
SOCKET HEAD CAP SCREW
Qty: 2
23
RIBBED LOCK WASHER
Qty: 6
YELLOW HARDWARE BAG CONTENTS :
15
14
Console wire
Ferrite cord
Console wire assembly through the ferrite and fasteners
fasteners
13
23
16
23
T7xe Shown
1716
MX15_T5x_T7xe_T7xi_OM_Rev2_2_DES.indd 16-17 2/2/15 9:58 AM