User's Manual

98
BATTERY CHARGE (3X, 5X ONLY)
The Stepper saves its battery charge by moving into a shutdown mode whenever STEP FASTER appears on the display. If the
user does not maintain a step rate above 35 steps per minute, then a 30-second shutdown process begins.
When the battery voltage is low, LOW BATTERY appears on the display if the unit is moving into the shutdown mode. The
following situation is the time to recharge the battery:
• If no one has used the unit for an extended period of time, the battery may need recharging.
• The unit continues to function with a low battery; however, user and program information is lost once the user stops.
If the battery must be recharged, use the optional power adapter charging unit. The charger should be connected to the Stepper
for a minimum of eight hours to ensure a thorough charge. After a completion of charge, the battery light turns from red into
green (see illustration). If LOW BATTERY still appears on the display after a full charge, the battery could be extinct. Please
check with an authorized service technician for replacing the battery.
CAUTION: The battery stored inside the unit contains hazardous materials to the environment. Proper disposal of the battery is
required by the local law.
• All video and power outlets must be
functional the day of delivery / assembly
of the product. The client is responsible
for any additional installation charges
associated with return visits.
• Electrical supply may fluctuate in your
area. To ensure stable performance of
the product, use the proper gauge wire.
Failure to follow these specifications can cause
damage to your product and can void the warranty.
Connect this exercise product to
a properly grounded outlet only.
Never operate product with a
damaged cord or plug even if
it is working properly. Never
operate any product if it
appears damaged, or has been
immersed in water. Contact
Customer Tech Support for
replacement or repair.
WARNING:DANGER
Improper connection of the
equipment-grounding conductor
can result in a risk of electric shock.
Check with a qualified electrician or
serviceman if you are in doubt as
to whether the product is properly
grounded. Do not modify the plug
provided with the product. If it will
not fit the outlet, have a proper
outlet installed by a qualified
electrician.
STEPPER ASSEMBLY
There are several areas during the assembly process that special attention must be
paid. It is very important to follow the assembly instructions correctly and to make sure
all parts are firmly tightened. If the assembly instructions are not followed correctly,
the unit could have parts that are not tightened and will seem loose and may cause
irritating noises. To prevent damage to the unit, the assembly instructions must be
reviewed and corrective actions should be taken.
Before proceeding, find the unit’s frame serial number located near the on/off switch
as shown in the illustration and enter it in the space provided below. The console
serial number is located on a barcode sticker on the console, near the connection
between the console and the mast.
ENTER YOUR SERIAL NUMBERS AND MODEL NAME IN THE BOXES BELOW:
» Use the information above for initial setup and when calling for service.
WARNING
FRAME SERIAL NUMBER:
CONSOLE SERIAL NUMBER:
MODEL NAME:
MATRIX
CONSOLE SERIAL NUMBER LOCATION
FRAME SERIAL NUMBER LOCATION
MX15_S3x_5x_7xe_7xi_OM_Rev1_7_DES.indd 8-9 1/30/15 4:14 PM