Install Instructions

ManualsBrandsJohnson Controls ManualsDampers1-1/2" NPT Normally Open 2-Way Globe Valve, 3 to 6 psig (28.9 Cv)

Table Of Contents

Published in U.S.A. www.johnsoncontrols.com

VG7000 Series Bronze Control Valves Installation Instructions8

Metasys® and Johnson Controls® are registered trademarks of Johnson Controls, Inc.

Building Efficiency

507 E. Michigan Street, Milwaukee, WI 53202

Valve Fluid Operating

Temperature Limits

Brass Trim

Valve with

Pneumatic

Actuator

For V-3801-8001 and V-3000-8003 Actuators:

35 to 248°F (2 to 120°C) Water; 15 psig (103 kPa) Saturated Steam

For MP82 and V-3000-8012 Actuators:

35 to 284°F (2 to 140°C) Water; 38 psig (262 kPa) Saturated Steam

Brass Trim

Valve with

Electric

Actuator

For VA-8x2x Actuators:

195°F (91°C) Maximum Water; Actuators are not rated for steam.

For VA-4233-xGx-2 Actuators:

35 to 250°F (2 to 121°C) Water; 15 psig (103 kPa) Saturated Steam

For All Other Electric Actuators:

35 to 284°F (2 to 140°C) Water; 38 psig (262 kPa) Saturated Steam

SS Trim

Valve with

Pneumatic

Actuator

All Pneumatic Actuators:

35 to 338°F (2 to 170°C) Water; 100 psig (690 kPa) Saturated Steam

SS Trim

Valve with

Electric

Actuator

For VA-4233-xGx-2 Actuators:

35 to 250°F (2 to 121°C) Water; 15 psig (103 kPa) Saturated Steam

For All Other Electric Actuators:

35 to 338°F (2 to 170°C) Water; 100 psig (690 kPa) Saturated Steam

Actuator Ambient Operating

Temperature Limits

Refer to the appropriate actuator or linkage kit product bulletin. Ambient

operating temperature or other service limitations vary by selected

actuator.

Compliance 1/2, 3/4, and

1 in. Valves

Pressure Equipment Directive (PED) 97/23/EC:

Paragraph 3, Comma 3 (CE Marking not Applicable.)

1-1/4, 1-1/2,

and 2 in.

Valves

Pressure Equipment Directive (PED) 97/23/EC:

Category 1, Mod. A (Subject to CE Marking)

All Valve

Sizes

CRN: C1099.9087YTN

1. Proper water treatment is recommended; refer to VDI 2035 Guideline.

2. Rangeability is defined as the ratio of maximum flow to minimum controllable flow.

The performance specifications are nominal and conform to acceptable industry standards. For application at conditions beyond these

specifications, consult the local Johnson Controls office. Johnson Controls, Inc. shall not be liable for damages resulting from misapplication or

misuse of its products.

VG7000 Series Bronze Control Valves (Part 3 of 3)