Brochure

Table Of Contents
The performance specifications are nominal and conform to acceptable industry standards. For applications at conditions beyond these specifications, consult the local Johnson Controls office.
Johnson Controls, Inc. shall not be liable for damages resulting from misapplication or misuse of its products. © 2014 Johnson Controls, Inc.
www.johnsoncontrols.com
V–92
VG1000 Series Two-Way, Plated Brass Trim, NPT End Connections Ball Valves with
Non-Spring-Return Electric Actuators (Continued)
Threaded Ball Valves and Actuators
Technical Specifications
VG1000 Series Two-Way, Plated Brass Trim, NPT End Connections Ball Valves with Non-Spring-Return Electric Actuators
Service
1
1. Proper water treatment is recommended; refer to the VDI 2035 Guideline.
Hot Water, Chilled Water, or 50/50 Glycol Solutions for HVAC Systems
Valve Fluid Temperature
Limits
Water 23 to 203F (-5 to 95C)
Steam Not Rated for Steam Service
Maximum Actuator Fluid
Temperature Limit
203°F (95°C) VA9104 Series Non-Spring-Return Actuators
M9104 Series Non-Spring-Return Actuators with M9000-550 Linkage
M9106 or M9109 Series Non-Spring-Return Actuators with M9000-520 Linkage
Valve Body Pressure Rating Water 580 psig (4,000 kPa) (PN40)
Steam Not Rated for Steam Service
Maximum Closeoff Pressure 200 psid (1,378 kPa)
Maximum Recommended Operating Pressure Drop 50 psid (340 kPa)
Flow Characteristics Two-Way Equal Percentage
Rangeability
2
2. Rangeability is defined as the ratio of maximum controllable flow to minimum controllable flow.
Greater than 500:1
Minimum Ambient Operating Temperature -4°F (-20°C)
Maximum Ambient Operating
Temperature
3
(Limited by the
Actuator and Linkage)
3. In steam applications, install the valve with the stem horizontal to the piping, and wrap the valve and piping with insulation.
140°F (60°C) VA9104 Series Non-Spring-Return Actuators
M9104 Series Non-Spring-Return Actuators with M9000-550 Linkage
125°F (52°C) M9106 and M9109 Series Non-Spring-Return Actuators with M9000-520 Linkage
Leakage 0.01% of Maximum Flow per ANSI/FCI 70-2, Class 4
End Connections National Pipe Thread (NPT)
Materials Body Forged Brass
Ball Chrome Plated Brass
Blowout-Proof Stem Nickel Plated Brass
Seats Graphite-Reinforced PTFE with Ethylene Propylene Diene Monomer (EPDM) O-Ring Backing
Stem Seals EPDM Double O-Rings
Characterizing Disk Amodel
® AS-1145HS Polyphthalamide Resin
Threaded Ball Valves and
Actuators
Threaded Ball Valves and
Actuators