Brochure

Table Of Contents
The performance specifications are nominal and conform to acceptable industry standards. For applications at conditions beyond these specifications, consult the local Johnson Controls office.
Johnson Controls, Inc. shall not be liable for damages resulting from misapplication or misuse of its products. © 2014 Johnson Controls, Inc.
www.johnsoncontrols.com
V–24
M9106-xGx-2 Series Electric Non-Spring-Return Actuators
Description
The M9106-xGx-2 Series direct-mount electric
actuators operate on AC 24 V power and are
available for use with on/off, floating, or
proportional controllers. These
non-spring-return actuators are easily installed
on a VAV box, a damper with a round shaft up
to 1/2 in. (13 mm) in diameter, or a square
shaft up to 3/8 in. (10 mm). The M9106 with an
M9000-520 linkage can also be used to
position VG1000 Series 1/2 in. (DN15) to
1-1/2 in. (DN40) ball valves.
The M9106 Series models have 53 lb·in
(6 N·m) running torque. These actuators have
a nominal 60-second travel time for 90° of
rotation at 60 Hz (72 seconds at 50 Hz) with a
load-independent rotation time.
The M9106-xGC-2 models are available with
integral auxiliary switches to perform switching
functions at any angle within the selected
rotation range. The -GGx models feature
DC 0(2) to 10 V position feedback, and the
-AGF models provide 10,000 ohm position
feedback.
Features
simple direct coupling reduces installation
and commissioning time and improves
reliability by eliminating damper linkages;
single screw coupling provides three-point
shaft gripping
designed for zone damper and ball valve
actuator applications
small, compact design allows installation in
tight-fitting locations
on/off, floating, and proportional control
inputs
60-second running time at 60 Hz
long life brushless synchronous drive motor
technology provides constant running time
independent of load
robust 53 lb·in (6 N·m) torque rating
whisper quiet 35 dBA noise rating
magnetic clutch provides over torque
protection over the entire range of rotation
-4 to 125°F (-20 to 52 °C) ambient
temperature rating
100,000 full stroke cycle, 2,500,000
reposition rating
manual gear release simplifies setup and
field adjustments
1/2 in. NPT threaded conduit opening
meets electrical code requirements and
allows the use of flexible armored cable
position feedback (-GGX models) provides
simple, closed-loop control with accurate
position sensing
adjustable rotation stops allow application
versatility with 30 to 90° clockwise or
counterclockwise rotation
Applications
The M9106 actuators are used to position
balancing, control, round, and zone dampers
in typical HVAC applications. The M9106 can
also be used with an M9000-520 linkage to
control 1/2 in. (DN15) to 1-1/2 in. (DN40)
VG1000 Series ball valves. The M9106 Series
actuator mounts directly on the duct surface,
round damper, or small rectangular damper
with an anti-rotation bracket and two sheet
metal screws (included). Additional linkages or
couplers are not required.
Refer to the damper or VAV box
manufacturer’s information to select the
proper timing for the actuator. Refer to the
appropriate application note for specific wiring
diagrams and information.
Refer to the M9106-xGx-2 Electric
Non-Spring-Return Actuators Product Bulletin
(LIT-2681123) or the M9106-xGx-2 Electric
Non-Spring-Return Actuators Installation
Instructions (Part No. 34-636-1085) for
important product application information.
Repair Information
If the M9106-xGx-2 Series Electric Actuator
fails to operate within its specifications,
replace the unit. For a replacement actuator,
contact the nearest Johnson Controls®
representative.
Code No. LIT-1900118
Selection Chart
Code Number Control Type Torque / Timing / Voltage Auxiliary Switches Comments
M9106-AGA-2
1
1. To avoid excessive wear or dive time on the motor for the -AGx models, use a controller and/or software that provides a time-out function to remove the signal at
the end of rotation (stall). The -GGx and -IGx models have an auto shutoff to avoid excessive wear or drive time on the motor.
Floating 53 lb·in (6 N·m)
60 seconds at 60 Hz
AC 24 V 50/60 Hz
None
M9106-AGC-2
1
2-SPDT
M9106-AGF-2
1
Floating with resistive feedback None 10,000 ohm feedback pot
M9106-GGA-2 DC 0(2) to 10 V
DC 0(4) to mA proportional
None DC 0(2) to 10 V feedback
M9106-GGC-2 2-SPDT
M9106-IGA-2 On/off / floating with timeout None Adjustable timing 1, 1.5, 2, 5.5, or 11 minutes
M9106-IGC-2 2-SPDT
M9106-xGx-2 Series
Electric Non-Spring-Return Actuator
Electric Damper Actuators
Electric Damper Actuators
Electric Damper Actuators
Electric Damper ActuatorsElectric Damper Actuators