Brochure

Table Of Contents
The performance specifications are nominal and conform to acceptable industry standards. For applications at conditions beyond these specifications, consult the local Johnson Controls office.
Johnson Controls, Inc. shall not be liable for damages resulting from misapplication or misuse of its products. © 2014 Johnson Controls, Inc.
www.johnsoncontrols.com
V–107
VG1000 Series Three-Way, Plated Brass Trim, NPT End Connections Ball Valves with
Spring-Return Electric Actuators without Switches (Continued)
Threaded Ball Valves and Actuators
Technical Specifications
VG1000 Series Three-Way, Plated Brass Trim, NPT End Connections Ball Valves with
Spring-Return Electric Actuators without Switches
Service
1
1. Proper water treatment is recommended; refer to the VDI 2035 Guideline.
Hot Water, Chilled Water, 50/50 Glycol Solutions
Fluid Temperature Limits Water 23 to 203°F (-5 to 95°C)
Steam Not Rated for Steam Service
Valve Body Pressure Rating Water 580 psig (4,000 kPa) (PN40)
Steam Not Rated for Steam Service
Maximum Closeoff Pressure 200 psid (1,378 kPa)
Maximum Recommended Operating Pressure Drop 50 psid (340 kPa)
Flow Characteristics Three-Way Equal Percentage Flow Characteristics of In-Line Port A (Coil) and Linear Flow Characteristics of
Angle Port B (Bypass)
Rangeability
2
2. Rangeability is defined as the ratio of maximum controllable flow to minimum controllable flow.
Greater than 500:1
Minimum Ambient Operating
Temperature
-22°F (-30°C) VA9203 Series Spring-Return Actuators
-40°F (40°C) VA9208 Series Spring-Return Actuators
Maximum Ambient
Operating Temperature
3
(Limited by
the Actuator and Linkage)
3. In steam applications, install the valve with the stem horizontal to the piping and wrap the valve and piping with insulation.
140°F (60°C) Direct Mount: VA9203 or VA9208 Series Spring-Return Actuators
Leakage 0.01% of Maximum Flow per ANSI/FCI 70-2, Class 4
1% of Maximum Flow for Three-Way Bypass Port
End Connections National Pipe Thread (NPT)
Materials Body Forged Brass
Ball Chrome Plated Brass
Blowout-Proof
Stem
Nickel Plated Brass
Seats Graphite-Reinforced PTFE with Ethylene Propylene Diene Monomer (EPDM) O-Ring Backing
Stem Seals EPDM Double O-Rings
Characterizing Disk Amodel
® AS-1145HS Polyphthalamide Resin
Threaded Ball Valves and
Actuators
Threaded Ball Valves and
Actuators
Threaded Ball Valves and
Actuators
Threaded Ball Valves and
Actuators