Actuator Install Instructions

VA9208-AGx-x Series On/Off and Floating Point Electric Spring Return Valve Actuators Installation

Instructions

Accessories

Mounting

Mounting the Actuator to Spring Return Port A

(Coil) Open

To mount the actuator to Spring Return Port A (Coil)

open:

1. Turn the valve stem to the position outlined in

Figure 4.

2. Mount optional M9000-561 Thermal Barrier to the

valve if fluid temperature exceeds 212°F (100°C).

See the Mounting the Thermal Barrier

section for

more information.

Note: Proceed to Step 7 if the ball valve linkage is on

actuator Side B.

3. Remove the linkage from Side A (Figure 5).

Table 3: Accessories (Order Separately)

Code Number Description

M9000-200 Commissioning Tool that Provides a Control Signal to Drive 24 V On/Off, Floating, Proportional, and/or

Resistive Electric Actuators

M9000-560 Ball Valve Linkage Kit for applying M9203 and M9208 Series Actuators to VG1000 Series Valves

(Quantity 1)

M9000-561 Thermal Barrier Extends M(VA)9104, M(VA)9203, and M(VA)9208 Series Electric Spring Return Actuator

Applications to Include Low Pressure Steam (Quantity 1)

M9000-341 Weathershield Kit for VG1000 Series Ball Valve application of M(VA)9104, M(VA)9203, and M(VA)9208

Series Electric Spring Return Actuators (Quantity 1)

M9208-604 Replacement Manual Override Cranks with Long Crank Radius: 2.83 in. (72 mm) (Quantity 5)

M9208-605 Replacement Manual Override Cranks with Short Crank Radius: 1.83 in. (46.5 mm) (Quantity 5)

Figure 4: Positioning the Valve Stem

3 Way2 Way

Figure 5: Removing the Linkage