Install Instructions

ManualsBrandsJohnson Controls ManualsHeating Supplies8" Flange Mount Nickel Wire Temperature Sensor (1k ohm)

Table Of Contents

TE-6300P Series Temperature Sensors Installation Instructions 3

To remove the sensor holder from the conduit box,

slide the retainer off of the sensor probe. Push the snap

finger toward the center of the sensor holder and pull

the holder out of the conduit box.

Note: It may be necessary to loosen the set screw

and remove the sensor probe to obtain adequate

clearance to slide the sensor holder out of the conduit

box.

Mounting the Temperature Sensors

Mounting the Duct Sensor

See Figure 5 and mount the sensor as follows:

1. Drill a 1-3/8 in. (35 mm) diameter hole at the

desired mounting location.

2. Use the mounting plate as a template to drill four

1/8 in. (3 mm) holes for the screws.

3. Mount the probe assembly to the duct using the

four screws provided.

4. Pull the wires into the conduit box and snap the

conduit box onto the sensor holder.

5. Install the retainer into the sensor holder.

6. Wire the sensor to the controller using the wire nuts

provided.

7. Reposition the cover and tighten the retention

screws.

Mounting the Duct Averaging Sensor

See Figure 6 to mount a single duct averaging sensor.

See Figure 7 to mount four duct averaging sensors in

series-parallel for larger ducts. Mount the duct

averaging sensor as follows:

1. Drill a 1-3/8 in. (35 mm) diameter hole at the

desired mounting location.

2. Use the mounting plate as a template to drill four

1/8 in. (3 mm) holes for the screws.

3. Mount the averaging sensor probe inside the duct

using a TE-6001-8 or equivalent 3 in. (76 mm)

minimum radius temperature element holder.

Note: Platinum sensor models include two TE-6001-8

Element Holders.

4. Insert the sensor probe into the sensor holder and

mounting plate assembly. Firmly tighten the sensor

holder set screw.

5. Follow Steps 3 through 7 in Mounting the Duct

Sensor.

Figure 6: Installing the Duct Averaging Sensor

IMPORTANT: Do not bend the sensor probe tighter

than a 3 in. (76 mm) radius, a 6 in. (152 mm)

diameter, to avoid permanently damaging the

sensor.

Figure 7: Series-Parallel Mounting Configuration