Install Instructions

24- 4034- 204, Rev. C
Installation Instructions TE-6300P Wall Mount
Issue Date March 2016
© 2016 Johnson Controls, Inc. 1
Part No. 24-4034-204, Rev. C www.johnsoncontrols.com
TE-6300P Series Wall Mount Temperature Sensors
Applications
North American Emissions Compliance
IMPORTANT: The TE-6300P Series Wall
Mount Temperature Sensor is intended to provide an
input to equipment under normal operating
conditions. Where failure or malfunction of the
sensor could lead to personal injury or property
damage to the controlled equipment or other
property, additional precautions must be designed
into the control system. Incorporate and maintain
other devices, such as supervisory or alarm systems
or safety or limit controls, intended to warn of or
protect against failure or malfunction of the sensor.
IMPORTANT: Le TE-6300P Series Wall Mount
Temperature Sensor est destiné à transmettre des
données entrantes à un équipement dans des
conditions normales de fonctionnement. Lorsqu'une
défaillance ou un dysfonctionnement du sensor
risque de provoquer des blessures ou
d'endommager l'équipement contrôlé ou un autre
équipement, la conception du système de contrôle
doit intégrer des dispositifs de protection
supplémentaires. Veiller dans ce cas à intégrer de
façon permanente d'autres dispositifs, tels que des
systèmes de supervision ou d'alarme, ou des
dispositifs de sécurité ou de limitation, ayant une
fonction d'avertissement ou de protection en cas de
défaillance ou de dysfonctionnement du sensor.
Installation
IMPORTANT: Do not install the TE-6300P
Series Wall Mount Temperature Sensor in ambient
temperatures beyond the specified -50 to 122°F
(-46 to 50°C) temperature range. Installing the
temperature sensor in ambient temperatures beyond
this range may damage the unit and void the
warranty.
Dimensions
T
E
-
6
3
0
0
P
i
i
0
1
.
c
d
r
Figure 1: Sensor Dimensions, in. (mm)
Accessories
To mount the TE-6300P Series Wall Mount Sensor to
an electrical box, order the TE-1800-9600 Mounting
Hardware. To order a different cover for the wall mount
sensor, refer to the TE-6300 Series Temperature
Sensors Product Bulletin (LIT-216320).
Mounting
Location Considerations
Consider the following mounting location guidelines:
• Avoid areas subject to excessive vibration,
electrical noise, direct sunlight, or the effects of
radiant heat.
• Keep electrical wiring as short as possible to
minimize temperature error.
Mounting the Temperature Sensor
See Figure 2 and mount the temperature sensor as
follows:
1. Loosen the socket-head screws on each side of
the unit with a 0.62 in. hex key and remove the
cover.
2. Drill the optional 5/16 in. (8 mm) hole only if using
the drywall anchors provided; then insert the
anchors into the holes.
3. Mount the base plate to the wall using the screws
provided.
4. Wire the sensor to the controller wire with the wire
nuts provided.