Install Instructions

P32 Technical Bulletin
3
Adjustments
The field adjustable switch has
an adjusting screw located
under the cover. Some models
have a scale plate for adjusting
convenience.
To adjust:
1. Remove cover.
2. Turn adjusting screw CW to
increase the set point.
3. Turn adjusting screw CCW
to decrease the set point.
4. If the high or low adjustment
stop is reached, turn
adjusting screw the other
way at least 1/6 turn from
the stop.
5. The factory setting must be
sealed by the OEM if the
original factory setting is
altered.
The adjusting screw must be
sealed. If this is not done at the
factory, then it must be sealed at
the equipment’s point of
manufacture by the Original
Equipment Manufacturer.
Checkout Procedure
Before leaving the installation,
observe at least three complete
operating cycles to be sure that
all components are functioning
correctly.
Repairs and Replacement
Field repairs must not be made.
These controls must be replaced
with an exact replacement. For
a replacement P32, contact the
nearest Johnson Controls
wholesaler or the manufacturer
of the appliance.